Table of Contents
Advertisement
Chapter 2. Hardware components
This section contains information about each of the components in the D3 Chassis and SD535 V3 node.
Front view
The following sections show the controls, LEDs, and connectors on the front of the D3 Chassis and SD535
V3 node.
Chassis front view
The following illustrations show the front view of the chassis installed with nodes.
The ThinkSystem D3 Chassis can contain up to four 1U nodes or up to two 2U nodes.
Important:
• For proper cooling, each node tray must be installed with either a node or node tray fillers before the
nodes in the chassis are powered on.
• The installation of nodes must follow the sequence of the tray numbering.
Four 1U nodes
For four 1U nodes: the two nodes in the right trays (
The following illustration shows the front view of the chassis and respective node trays in the chassis.
Figure 1. Chassis front view with four 1U nodes
Node tray 3
3
Node tray 1
1
Node front view
The following illustrations show the controls and connectors in the front view of the ThinkSystem SD535 V3
node. Depending on the specific configuration, some of the components or connectors might not be
supported.
Configuration with six 2.5-inch SAS/SATA/NVMe SSDs
See the following illustration for components and connectors in the configuration with six 2.5-inch SAS/
SATA/NVMe SSDs.
© Copyright Lenovo 2024
and
) must be installed upside down.
2
4
Node tray 4
4
Node tray 2
2
19
Advertisement
Table of Contents
