Info
The fluid level rises with increasing wear of the clutch facing discs.
Never use DOT 5 brake fluid. It is silicone-based and purple in color. Oil seals and clutch lines are not
designed for DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint.
Only use clean brake fluid from a sealed container.
12.30
Removing engine guard
12.31
Installing the engine guard
SERVICE WORK ON THE CHASSIS 12
–
Move the clutch fluid reservoir mounted on the handlebar to a
horizontal position.
–
Remove screws
–
Take off cover
–
Check the fluid level.
A
Fluid level
tainer rim
»
If the fluid level does not meet specifications:
–
Correct the fluid level of the hydraulic clutch.
V00501-10
Brake fluid DOT 4 / DOT 5.1 (
–
Position the cover with the membrane. Mount and tighten the
screws.
Info
Clean up overflowed or spilled brake fluid immediately
with water.
–
Remove screws
–
Pull the engine guard forward out of the holders and remove
it.
V01479-10
–
Slide the engine guard into holders
–
Position the engine guard. Mount and tighten screws
both sides.
Guideline
Remaining screws,
chassis
V01479-11
1
.
2
3
with membrane
.
4 mm (0.16 in)
below con-
p. 131)
1
on both sides.
1
at the rear.
M6
10 Nm (7.4 lbf ft)
2
on
65