Combination Switch; Ignition And Steering Lock - Husqvarna 701 Enduro 2023 Owner's Manual

6.9

Combination switch

6.10

Ignition and steering lock

The combination switch is fitted on the left side of the handlebar.
Possible states
ROAD – Drive mode ROAD and traction control are
1
activated when LED 1 lights up.
ROAD without TC – When LEDs 1 and TC light up,
1TC
drive mode ROAD is active and traction control is
deactivated.
OFFROAD – Drive mode OFFROAD and traction
2
control are activated when LED 2 lights up.
V01903-01
OFFROAD without TC – When LEDs 2 and TC light
2TC
up, drive mode OFFROAD is active and traction con-
trol is deactivated.
The combination switch displays the current drive mode and
traction control setting.
The drive mode is changed using button MAP on the combina-
tion switch.
The traction control is activated or deactivated using button TC
on the combination switch.
Info
Each time the ignition is switched on, all three switch
LEDs light up for a function check.
If all three LEDs light up during operation, a malfunction
has been detected by the engine control unit. Contact an
authorized Husqvarna Motorcycles workshop immedi-
ately.
H02887-01
The ignition and steering lock is located in front of the seat.
Possible states
Ignition off OFF – In this position, the ignition circuit
is interrupted, a running engine stops, and a non-
running engine will not start. The ignition key can be
removed.
Ignition on ON – In this position, the ignition circuit is
closed and the engine can be started.
Steering locked – In this position, the ignition circuit
S00994-01
is interrupted and the steering locked. The ignition
key can be removed.
CONTROLS 6
21