Removing The Engine Guard; Installing The Engine Guard - Husqvarna FE 501s 2022 Owner's Manual

12.45

Removing the engine guard

12.46

Installing the engine guard

SERVICE WORK ON THE CHASSIS 12
–
Inject the liquid into the system until it escapes from open-
6
ings of the master cylinder without bubbles.
–
Occasionally extract the fluid from the master cylinder reser-
voir to prevent overflowing.
–
Remove the bleeding syringe. Mount and tighten the bleeder
screw. Mount the protection cap.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
F03505-10
rim
–
Position the cover with the membrane. Mount and tighten the
screws.
Info
Use water to immediately clean up any brake fluid that
has overflowed or spilled.
–
Remove screws
H01655-01
–
Attach the engine guard on the frame at the rear and swing
up at the front.
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
H01655-01
4 mm (0.16 in)
1
and engine guard.
1
.
M6 10 Nm (7.4 lbf ft)
87