Table of Contents
Advertisement
Pairing Your Wireless Sensors
The first time you connect a wireless ANT+ or Bluetooth sensor to your Garmin device, you must pair the device
and sensor. After they are paired, the device connects to the sensor automatically when you start an activity
and the sensor is active and within range.
TIP: Some ANT+ sensors pair with your device automatically when you start an activity with the sensor turned
on and near the device.
1 Move at least 10 m (33 ft.) away from other wireless sensors.
2 If you are pairing a heart rate monitor, put on the heart rate monitor.
The heart rate monitor does not send or receive data until you put it on.
3 Hold
.
4 Select
> Sensors > Add New.
5 Bring the device within 3 m (10 ft.) of the sensor, and wait while the device pairs with the sensor.
After the device connects to the sensor, an icon appears at the top of the screen.
Foot Pod
Your device is compatible with the foot pod. You can use the foot pod to record pace and distance instead of
using GPS when you are training indoors or when your GPS signal is weak. The foot pod is on standby and
ready to send data (like the heart rate monitor).
After 30 minutes of inactivity, the foot pod powers off to conserve the battery. When the battery is low, a
message appears on your device. Approximately five hours of battery life remain.
Calibrating Your Foot Pod
Before you can calibrate your foot pod, you must pair your device with the foot pod
Sensors, page
46).
Manual calibration is recommended if you know your calibration factor. If you have calibrated a foot pod with
another Garmin product, you may know your calibration factor.
1 Hold
.
2 Select
> Sensors > Foot Pod > Cal. Factor.
3 Adjust the calibration factor:
• Increase the calibration factor if your distance is too low.
• Decrease the calibration factor if your distance is too high.
Improving Foot Pod Calibration
Before you can calibrate your device, you must acquire GPS signals and pair your device with the foot pod
(Pairing Your Wireless Sensors, page
The foot pod is self-calibrating, but you can improve the accuracy of the speed and distance data with a few
outdoor runs using GPS.
1 Stand outside for 5 minutes with a clear view of the sky.
2 Start a running activity.
3 Run on a track without stopping for 10 minutes.
4 Stop your activity, and save it.
Based on the recorded data, the foot pod calibration value changes, if necessary. You should not need to
calibrate the foot pod again unless your running style changes.
Using an Optional Bike Speed or Cadence Sensor
You can use a compatible bike speed or cadence sensor to send data to your device.
• Pair the sensor with your device
• Set your wheel size
(Calibrating Your Speed Sensor, page
• Go for a ride
(Going for a Ride, page
46
46).
(Pairing Your Wireless Sensors, page
25).
46).
47).
(Pairing Your Wireless
Wireless Sensors
Advertisement
Table of Contents
