9.19 CHOKE CONTROL _________________________________________________________
1. Push choke control knob to the Off Position.
2. Set choke lever at carburetor to Off (butterfly open)
position.
9.20 SPECIFIC TORQUE REQUIREMENTS _________________________________________
1. Ball joints: 30 - 35 ft lb. (40.5 - 47.2 Nm).
2. Bedknife shoe: 25 - 37 ft lb. (34 - 50 Nm).
3. Brake drum and hub to wheel motor: 90 - 100 ft. lb.
(122 - 135 Nm).
4. Wheel mounting hardware: 65-85 ft lb. (88 - 115
Nm). Check and torque daily until torque is
maintained.
5. Rear steering pulley: 50 - 60 ft lb. (67.5 - 81 Nm).
6. Engine drain plug: 22 ft lb. (29.7 Nm).
3. Adjust control wire (at the carburetor) then clamp
wire housing in place while keeping choke butterfly
open and the control knob in the Off position.
ADJUSTMENTS
9
43