HP HPE Alletra 2140 Hardware Manual page 110

1 Thumbscrew
2 PCIe card holder
b) Open the PCIe card holder.
1 PCIe card
2 Connector
c) Pull the PCIe card straight out of the card slot.
7. Insert the new PCIe card.
a) Insert the PCIe card into the card slot.
b) Align the rubber tabs with PCIe cards, and close the PCIe card holder.
c) Tighten the thumbscrew to secure the PCIe card.
8. Install the PCIe cage into the controller.
For the primary cage (left), proceed to Step 9.
For the secondary cage (right), proceed to Step 10.
9. Install the primary PCIe cage (left) into the controller.
a) Align the PCIe cage and guide post with the grooves of the controller, and lower the cage into the controller.
3 PCIe card
4 Riser card
3 Rubber tab
4 PCIe cage slot
Documentation Feedback: doc-feedback-hpe-storage@hpe.com
Upgrade Procedures 110