Routing Sound To The Individual Output - Boss Dr. Rhythm DR-770 Owner's Manual

Chapter 8. Creating an Original Drum Kit
If you wish to set the Flanger Send Level for the
instruments of pad numbers 33 (-01)–55 (-23), use the
following procedure to select the pad number.
1) Press [ENTER].
2) Use [ ] [ ]] to select the pad number.
At this time, you can press [ENTER] to play the
instrument.
4. Use [VALUE*] to adjust the Flanger Send Level.
Range: 0–9
By pressing [STOP/EXIT] you can return to the Flanger
Level setting (the display will indicate "ALL").
If in step 3 you use [PAD BANK] to layer the pad banks, you
can set the Flanger Send Level for instruments of both banks
A and B simultaneously.
This is a convenient way to make settings for a drum kit that
uses pad bank layering.
However, if different values have been set for banks A and B,
using [VALUE*] will adjust the values while preserving their
proportion.
fig.108-36a
PAD BANK A B
TEMPO DPP
DRUM KIT
REVERB IND
FLANGER
PATTERN
SONG
PAD NUMBER
82
Flanger Send Level of
pad number A13
Flanger Send Level of
pad number B13
Routing Sound to the
Individual Output
For each instrument of a drum kit, you can specify whether
the sound will be sent from the individual output.
fig.108-36b
POWER AC IN 14V
700mA
ON
OFF
OUT MIDI IN
USE BOSS BRC
ADAPTOR ONLY
Audio cable
Power Amplifier
MEMO
Effects (reverb/flanger/equalizer) will not be applied to the
sound that is sent from the individual output. Nor is it
possible to adjust the output level (volume).
NOTE
Instruments that are sent from the individual output will not be
output from the stereo outputs.
NOTE
When you use the individual output, reverb will not be applied to
the sound from the stereo outputs either.
NOTE
The Ambience cannot be used for the drum kit where the individual
has been set.
PHONES PEDAL SW INDIVIDUAL OUTPUT
R L(MONO)
MADE IN JAPAN
Mixer etc.