Table of Contents
Advertisement
•
Use a single-cut flat file.
WARNING:
that is damaged. Do not try to make a bent
or twisted blade straight and use it again.
To lubricate the bevel gear
1. Remove the cutting equipment.
2. Put the product with the grease plug at its highest
position.
3. Remove the grease plug.
20
Always discard a blade
4. Look into the grease plug hole and turn the drive
shaft. The grease level (A) must be in level with the
top of the gear cogs (B).
A
5. If the grease level is too low fill the bevel gear with
Husqvarna bevel gear grease. Fill slowly and turn
the drive shaft as you apply the bevel gear grease,
stop at the correct level (B).
CAUTION:
grease can cause damage to the bevel
gear.
6. Install the grease plug.
B
An incorrect quantity of
1858 - 004 - 02.06.2023
Advertisement
Table of Contents
