Table of Contents
Advertisement
Cleaning
en
Descale
The appliance must be descaled regularly in order for it
to continue operating correctly.
There are several steps in the descaling programme. All
steps must be completed in full. Only after this is the
appliance ready for use again.
If you touch the k button during the descaling
Note:
programme, the process is interrupted and the
appliance switches off. Once the appliance has been
switched back on again, it must first be rinsed twice in
order to remove any remaining descaling solution from
the appliance. The appliance is locked for other
applications until the second rinsing cycle is complete.
Descale (approx. 30 minutes), then empty the
■
evaporator dish and refill the water tank
First rinsing cycle (20 seconds), then empty the
■
evaporator dish
Second rinsing cycle (20 seconds), then remove the
■
remaining water
The frequency with which the appliance must be
descaled depends on the hardness of the water used.
When only another five or fewer steam-assisted
operations are possible, the appliance reminds you to
descale it with a message on the display. The number
of remaining operations is displayed after the appliance
is switched on. You can therefore prepare for the
descaling in good time.
Starting
Caution!
Risk of damage to the appliance: Only use liquid
■
descalers recommended by us for the descaling
programme. The time the product needs to work
during descaling depends on the type of descaler
used. Other descalers may damage the appliance.
Descaler order no. 311 680
Descaling solution: Do not allow any descaling
■
solution or descaler to come into contact with the
control panel or other surfaces on the appliance.
This damages the surfaces. If this does happen,
remove the descaling solution immediately with
water.
Mix 300 ml water with 60 ml liquid descaler to make
1.
a descaling solution.
Remove the water tank and fill it with descaling
2.
solution.
Once the water tank has been filled with descaling
3.
solution, push it back in again fully.
Close the appliance door.
4.
Press the k button.
5.
Press the j button.
6.
The operating modes menu opens.
Touch the right-hand arrow repeatedly until
7.
"Descale" appears.
Press the u button to start descaling.
8.
You can see the remaining time counting down in
the status bar. A signal sounds once the remaining
time has fully elapsed.
20
First rinsing cycle
Press the u button.
1.
The appliance rinses. The first rinsing cycle ends
after around 20 seconds.
Open the appliance door.
2.
Thoroughly rinse out the cleaning sponge with water.
3.
Remove the remaining water in the evaporator dish
4.
using the cleaning sponge.
Proceed with the second rinsing cycle.
5.
Second rinsing cycle
Remove the water tank, rinse thoroughly, fill with
1.
water and reinsert.
Close the appliance door.
2.
Press the u button.
3.
The appliance rinses. The second rinsing cycle ends
after around 20 seconds.
Remove the remaining water in the evaporator dish
4.
using the cleaning sponge.
Wipe out the cooking compartment using the
5.
cleaning sponge and then dry with a soft cloth.
Switch off the appliance.
6.
Descaling is complete and the appliance is ready for
use again.
Descaling the evaporator dish only
You can also use "Descale" if you do not wish to
descale the whole appliance, but only the evaporator
dish in the cooking compartment.
The only difference is as follows:
Mix 100 ml water with 20 ml liquid descaler to make
1.
a descaling solution.
Completely fill the evaporator dish with descaling
2.
solution.
Fill the water tank with water only.
3.
Start "Descale" as described.
4.
You can also descale the evaporator dish manually.
Advertisement
Table of Contents
