Table of Contents
Advertisement
Insert the filled water tank (picture
5.
Check whether the water tank is pushed in flush with
6.
the water tank recess (picture
Close the appliance
7.
door.
The water tank has been filled. You can now start the
operation.
Refilling the water tank
If the water tank is empty, the prompt to fill the water
tank appears on the display. The operation is stopped.
:
Warning – Risk of scalding!
When you open the appliance door, hot water may flow
out of the appliance. When opening the door, do not
stand too close to the appliance. Open the appliance
door carefully. Keep children away from the appliance.
If the evaporator dish overflows, do not pour more water
into the water tank.
Carefully open the appliance door.
1.
Remove the water tank and fill it.
2.
Slide the water tank back in and close the appliance
3.
door.
Start the operation.
4.
The operation continues.
Switching the appliance on and off
Before you are able to set the appliance, you must
switch it on.
Exception: The childproof lock and the timer can be set
when the appliance is switched off.
Displays or information, e.g the residual heat indicator
in the cooking compartment, remain visible in the
display after the appliance has been switched off.
Switch off your appliance when you do not need to use
it. If no settings are applied for a long time, the
appliance switches itself off automatically.
Switching the appliance on
Use the k button to switch the appliance on.
The k symbol above the button is illuminated in blue.
The Siemens logo appears in the display, and then a
heating mode and a temperature.
You can specify which heating mode should
Note:
appear after the appliance is switched on in the basic
settings. ~ "Basic settings" on page 18
).
#
).
$
Switching off the appliance
Use the k button to switch the appliance off.
The lighting above the button goes out.
A set function is cancelled.
The time appears on the display.
You can set whether or not the time should be
Note:
displayed when the appliance is switched off in the
basic settings. ~ "Basic settings" on page 18
Setting the type of heating and temperature
After the appliance is switched on, the suggested type
of heating appears with the temperature. You can apply
this setting immediately by pressing the u button.
For other settings, you can change the values as shown
in the pictures.
Example: Steaming at 90 °C
Use the rotary selector to change the type of
1.
heating.
Press the arrow ¿ to switch to the temperature.
2.
Use the rotary selector to change the temperature.
3.
Press the u button.
4.
The set type of heating and the temperature are shown
in the display.
"Fill water tank?" message
This message appears if you set a type of heating and
the water tank is only half full.
If you think that the water in the water tank is sufficient
for the cooking procedure, you can start the appliance.
If not, fill the water tank to the "max" mark, slide it back
in and start the appliance.
Operating the appliance
en
13
Advertisement
Table of Contents
