Table of Contents
Advertisement
Operating the appliance
en
Notes
So that the appliance adapts to a new installation
■
location after moving house, reset the appliance to
the factory settings. Repeat the initial use settings
and the calibration.
The appliance saves the calibration settings, even in
■
the event of a power cut or disconnection from the
mains. Recalibration is not necessary.
Cleaning the accessories
Clean the accessories thoroughly using soapy water
and a dish cloth or soft brush.
12
1Operating the appliance
Y ou have already learnt about the controls and how
O p e r a t i n g t h e a p p l i a n c e
they work. Now we will explain how to set your
appliance. You will learn about what happens when you
switch the appliance on and off, and how to select the
operating mode.
:
Warning – Risk of scalding!
When you open the appliance door, hot steam can
escape. Steam may not be visible, depending on its
temperature. When opening, do not stand too close to
the appliance. Open the appliance door carefully. Keep
children away.
:
Warning – Risk of scalding!
The water in the evaporator dish is still hot even after
the appliance has been switched off. Do not empty the
evaporator dish immediately after switching off the
appliance. Allow the appliance to cool down before
cleaning it.
:
Warning – Risk of scalding!
When you open the appliance door, hot water may flow
out of the appliance. When opening the door, do not
stand too close to the appliance. Open the appliance
door carefully. Keep children away from the appliance.
If the evaporator dish overflows, do not pour more water
into the water tank.
Filling the water tank
When you open the appliance door, you will see the
water tank on the right-hand side. Before starting the
operation, fill the water tank with water.
Ensure that you have correctly set the water hardness
range. ~ "Basic settings" on page 18
Caution!
The appliance may become damaged due to the use of
unsuitable liquids.
Do not use distilled water, highly chlorinated tap water
(> 40 mg/l) or other liquids.
Only use cold, fresh tap water, softened water or
uncarbonated mineral water.
Fill the water tank before each use:
Open the appliance door.
1.
Remove the water tank from the water tank recess
2.
(picture
).
!
Fill the water tank with cold water up to the "max."
3.
mark. (Picture
).
"
Close the tank cover
4.
until you feel it engage.
Advertisement
Table of Contents
