Table of Contents
Advertisement
2.A Inside Fit Method with Overlap Fit Front
FINISHING STRIPS REQUIRED
Non-Combustible Finishing Material Thickness:
1-6 Inches Maximum
Finishing strips will add the proper clearances for the
installation of the front.
DECORATIVE
BARRIER FRONT
MANOR
ENSEMBLE
VENTURA
NON-COMBUSTIBLE
FINISHING MATERIAL
NON-COMBUSTIBLE
FINISHING MATERIAL
DECORATIVE FRONT
Figure 10.15 Non-Combustible Finishing Material Thickness
Greater Than One Inch - Finishing Strips Required
FIT
OPTION
Inside
Inside
Inside
FINISHING
STRIPS
NON-COMBUSTIBLE
FINISHING MATERIAL
Majestic • MER36MN, MER42MN Installation Manual • 2599-980 Rev. B • 5/23
Install and Remove Finishing Strips
1. Align finishing strip with the two pre-drilled holes on
the appliance top and sides as shown in Figure 10.16.
2. Install screws to attach finishing strips.
3. To remove the finishing strips, remove screws.
Finishing strips will add the proper clearances for the
installation of the front.
NOTICE: Remove finishing strips before firing appliance.
Remove glass assembly to access finishing strip screws.
FINISHING STRIPS
FINISHING STRIP
ALIGNS WITH HOLES
FINISHING STRIP
ALIGNMENT DETAIL
Figure 10.16 Install Finishing Strips
65
Advertisement
Table of Contents
