Power Switch - Roland CUBE-30 Owner's Manual

Names of Things and What They Do
EFX (Effects)
10 . EFX (Effects) Knob
Turn this knob to chorus, flanger, phaser, or tremolo to
select the corresponding effect. Turn the knob to adjust the
amount of effect applied.
The ON indicator lights up when EFX is turned on, and
goes out when EFX is turned off. You can also turn EFX on
and off using an optional foot switch (the BOSS FS-5U).
* Graduations for CHORUS, FLANGER, PHASER,TREMOLO
on a panel are for reference. Be sure to check the sound as you
adjust the effects.
fig.02
CHORUS
In this effect, a slightly detuned sound
is added to the original sound, giving
the sound greater breadth and
fullness.
fig.03
FLANGER
This creates a flanging effect that
creates a sort of spinning sensation
with the sound.
fig.04
PHASER
This effect adds a variable phase-
shifted signal to the direct sound,
giving the sound a swirling character.
fig.05
TREMOLO
Tremolo is an effect that creates a
cyclic change in volume.
DELAY/REVERB
11 . DELAY/REVERB Knob
Turn this knob to DELAY or REVERB to switch to that effect.
Turn the knob to adjust the amount of effect applied.
* Graduations for DELAY, REVERB on a panel are for reference.
Be sure to check the sound as you adjust the effects.
fig.05a
DELAY
Turn the knob to change the delay time.
fig.05b
REVERB
Turn the knob to adjust the reverb level.
6
12 . FOOT SW (Foot Switch) Jack
You can use foot switches (the optional BOSS FS-5U)
connected using a connection cable (the optional PCS-31) to
switch channels (JC CLEAN/LEAD), and to turn EFX on
and off.
fig.06
PCS-31
white
SELECT EFX
* When you connect only one foot switch by mono cable, you can
only use it to switch channels (JC CLEAN/LEAD).
13 . AUX IN Jack
You can connect a CD player or other kind of device and
have it play along with your guitar.
This accepts a 1/4" stereo phone plug. However, the
speaker and RECORDING OUT/PHONES output is
monaural.
* Determine the volume level by adjusting the volume control of the
connected device.
14 . RECORDING OUT/PHONES Jack
fig.02
When Using RECORDING OUT
Use mono 1/4" phone plugs when connecting
to this jack.
Volume level of RECORDING OUT can be
easily adjusted if you set the VOLUME knob
of JC CLEAN or LEAD channel shown as
right side.
When Using Headphones
Connect headphones to this jack.
* No sound is played through the unit's speaker while the
RECORDING OUT/PHONES jack is in use.

15 . POWER Switch

Turns the power on and off.
* This unit is equipped with a protection circuit. A brief interval (a
few seconds) after power up is required before the unit will operate
normally.
red
Polarity Switch