Remote Punch Bass - Rockford Fosgate Punch 851X Installation And Operation Manual

Passive crossovers are directly dependent upon the speaker's impedance and component value for
accuracy. When passive crossover components are used in multiple speaker systems, the crossover's
effect on the overall impedance should be taken into consideration along with the speaker's
impedance when determining amplifier loads.
CAUTION: These amplifiers are not recommended for impedance loads below 2Ω
!
stereo and 4Ω bridged (mono).
L
6dB/Octave Low-Pass
C
6dB/Octave High-Pass
L = Low-Pass (Inductor)
C = High-Pass (Capacitor)
For more information, see your
Authorized Rockford Fosgate Dealer.

REMOTE PUNCH BASS

Mounting and installation
1. Find a location, either under the dash or
near the center console, that gives easy
access to the remote.
2. Using the screws supplied, install the
mounting clip with the tabs towards
the back.
3. Route the cable for the remote and
connect to both the remote and
amplifier.
4. Slip the remote onto the mounting clip
until it snaps into place.
5. Place the decal onto the remote and use
the nut to hold the decal in place. Do
not over tighten nut.
6. Install the knob onto the remote.
Speaker Impedance
Freq.
2 OHMS
Hertz
L C
80 4.1mH 1000µF
100 3.1mH 800µF
130 2.4mH 600µF
200 1.6mH 400µF
260 1.2mH 300µF
400 .8mH 200µF
600 .5mH 136µF
800 .41mH 100µF
1000 .31mH 78µF
1200 .25mH 66µF
1800 .16mH 44µF
4000 .08mH 20µF
6000 51mH 14µF
9000 34mH 9.5µF
12000 25mH 6.6µF
Mounting
Clip
Decal
Knob
Nut
I
NSTALLATION
4 OHMS
L C L
8.2mH 500µF 16mH
6.2mH 400µF 12mH
4.7mH 300µF 10mH
3.3mH 200µF 6.8mH
2.4mH 150µF 4.7mH
1.6mH 100µF 3.3mH
1.0mH 68µF 2.0mH
.82mH 50µF 1.6mH
.62mH 39µF 1.2mH
.51mH 33µF 1.0mH
.33mH 22µF .68mH
.16mH 10µF .33mH
.10mH 6.8µF .20mH
68mH 4.7µF .15mH
51mH 3.3µF 100mH
8 OHMS
C
250µF
200µF
150µF
100µF
75µF
50µF
33µF
26µF
20µF
16µF
10µF
5µF
3.3µF
2.2µF
1.6µF
9