Design Features Design Features Crossover Switch Output Clip Indicator Selectable switch for High-Pass (HP) or Punch EQ The output clip indicator works in conjunction with All Pass (AP) or Low-Pass (LP) the input level knob, illuminating to appropriate A Gyrator based Punch EQ that eliminates frequency color depending on the audio content used for the shift with boost.
Authorized NOTE: When utilizing high-level for input signal the auto turn-on feature Rockford Fosgate Dealer for installation. • Mounting Hardware • Operation CD- (Test Tones & 7. Never run wires underneath the vehicle. Running the wires inside the is active.
Installation Installation 2-Channel (Stereo) 2-Channel (Mono) P300X2, P400X2, P500X2, P1000X2 P300X2, P400X2, P500X2, P1000X2 PASS-THRU PASS-THRU Connect to inputs Connect to inputs of 2nd amplifier of 2nd amplifier *Installation option for *Installation option for multi-amp install multi-amp install LEFT LEFT REMOTE INPUT PASS-THRU...
Page 6
Installation Installation 4-Channel (Stereo) 4-Channel (2ch Stereo & 1ch Mono-Bridged) P400X4, P600X4 P400X4, P600X4 PASS-THRU PASS-THRU Connect to inputs Connect to inputs of 2nd amplifier of 2nd amplifier *Installation option for *Installation option for multi-amp install multi-amp install FRONT REAR FRONT REAR REMOTE...
Page 7
Installation Installation 4-Channel (2ch Mono-Bridged) 3-Channel (2ch bridged & 1ch Mono) P1000X5 P400X4, P600X4 PASS-THRU Connect to inputs of 2nd amplifier *Installation option for multi-amp install FRONT REAR LEFT LEFT FRONT REAR LEFT LEFT REMOTE REMOTE PUNCH LEVEL RIGHT RIGHT RIGHT RIGHT PUNCH LEVEL...
Page 8
Installation Installation 5-Channel (4ch Stereo & 1ch Mono) Parallel Wiring (Full Range Capable) P1000X5 P300X1, P400X1 PASS-THRU Connect to inputs of 2nd amplifier *Installation option for multi-amp install FRONT REAR LEFT LEFT LEFT REMOTE REMOTE INPUT PASS-THRU RIGHT RIGHT PUNCH LEVEL...
Installation Installation Mono Wiring Parallel Wiring P300X1, P400X1, P500X1BD, P1000X1BD P500X1BD, P1000X1BD PASS-THRU PASS-THRU Connect to inputs Connect to inputs of 2nd amplifier of 2nd amplifier *Installation option for *Installation option for multi-amp install multi-amp install LEFT REMOTE LEFT REMOTE...
Operation Operation Input Clip Indicator Setup illus.-3.1 Step 6. Decrease the source unit volume slightly until the light turns Adjusting Crossover Frequency signal the auto turn-on feature is active. With the auto turn-on active, illus.-4.1 illus.-4.2 completely off. This establishes your maximum source unit vol- REM becomes an output to turn on/off up to two additional amplifiers or Do the following individually for each ume for adjusting the Output Clip Indicator.
Connect stereo directly to input of amplifier. If noise goes This warranty applies only to Rockford Fosgate products sold to consumers by Authorized Rockford Fosgate Dealers in the United States of America or its away the unit being bypassed is the cause of the noise.
Page 12
Installation assistance available at www.rockfordfosgate.com/rftech 600 South Rockford Drive • Tempe, Arizona 85281 United States Direct : (480) 967-3565 • Toll Free : (800) 669-9899 R O C K F O R D F O S G A T E . C O M...