Husqvarna DE 110i H Operator's Manual page 20

3. Make sure that the battery is not damaged and there
are no other defects, such as cracks.
To clean the product
Operation can cause contamination on all parts of the
product and all used equipment. Thus it is necessary to
clean all parts of the product and all used equipment
fully and carefully.
WARNING:
from the power supply.
WARNING:
it is moved from the work area. Remaining
dust on the product can go into the air and
cause a health risk.
• Use personal protective equipment. Refer to
Personal protective equipment on page 9 .
• Do not clean the product with a high-pressure
washer or compressed air.
• Clean the external surface with a moist cloth.
• Do not use water on electrical components.
• Clean the filters as given in
water on page 20 and To replace the HEPA filter on
page 21 .
• After servicing, put discarded parts in plastic bags.
Refer to local regulations for the correct procedure.
• If you use water to clean the product, remove the
prefilter and the Longopac before you clean. Also
make sure that no water goes into the HEPA filter.
To clean the prefilter with water
CAUTION:
washer or compressed air to clean the
prefilter. Do not hit the prefilter with force to
clean it.
20
Disconnect the product
Clean the product before
To clean the prefilter with
Do not use a high-pressure
CAUTION:
sunlight. The seals will dry out.
Note:
To clean the with water will gradually decrease
the efficiency of the filter.
1. Loosen the cover locks (A) and open the prefilter
cover (B).
A
B
2. Remove the prefilter.
Do not let it dry in full
1618 - 006 - 01.06.2023