Pioneer VSX-1025 Operating Instructions Manual page 14

02 Controls and displays
///, ENTER
7
Use the arrow buttons when setting up your
surround sound system (page 88) and the
Audio or Video options (page 70 or 73).
8 Receiver controls
Press
RECEIVER
PHASE CTRL – Switch on/off Phase Control
(page 64).
STATUS – Check selected receiver settings
(page 77).
PQLS – Select PQLS setting (page 68).
S.RETRIEVER – Press to restore CD quality
sound to compressed audio sources
(page 71).
MIDNIGHT – Switches to Midnight or
Loudness listening (page 70).
SIGNAL SEL – Select an input signal
(page 63).
MCACC – Switch between MCACC presets
(page 63).
SLEEP – Use to put the receiver in sleep
mode and select the amount of time before
sleep (page 77).
CH LEVEL – Press repeatedly to select a
channel, then use / to adjust the level
(page 105).
A.ATT – Attenuates (lowers) the level of an
analog input signal to prevent distortion
(page 77).
DIMMER – Dims or brightens the display
(page 77).
9 LISTENING MODE controls
AUTO/ALC/DIRECT – Switches between
Auto Surround (page 59), Auto Level
Control mode and Stream Direct mode
(page 62).
STEREO – Switches between stereo
playback and Front Stage Surround
Advance modes (page 62).
STANDARD – Press for Standard decoding
and to switch between the various 2 Pro
Logic IIx and Neo:6 options (page 59).
14
En
first to access:
ADV SURR – Switch between the various
surround modes (page 61).
10 Remote control LED
Lights when a command is sent from the
remote control (page 79).
11 TV CTRL
Set preset code of your TV's manufacturer
when controlling TV (page 80).
12 RECEIVER
Switches the remote to control the receiver
(used to select the white commands above the
number buttons (SIGNAL SEL, etc.)).
Switch to perform operations in the main zone.
Also use to set up surround sound.
13 MASTER VOLUME +/–
Set the listening volume.
14 MUTE
Mutes the sound or restores the sound if it has
been muted (adjusting the volume also
restores the sound).
Operating range of remote control
unit
The remote control may not work properly if:
• There are obstacles between the remote
control and the receiver's remote sensor.
• Direct sunlight or fluorescent light is
shining onto the remote sensor.
• The receiver is located near a device that is
emitting infrared rays.
• The receiver is operated simultaneously
with another infrared remote control unit.
30°
30°
7 m (23 ft.)