Unix Configuration; Before Setup; Using The Lp / Lpr Commands; Using The Rsh / Rcp / Ftp Commands - Ricoh AP410 Supplementary Manual

This section explains how to set up a network printer and check print status us-
ing UNIX.
Limitation
❒ To print from a UNIX workstation, use a file that the printer supports.

Before Setup

Setting up varies depending on the printing commands. Make sure to make set-
tings accordingly.

Using the lp / lpr commands

A A A A
Use the installation shell script to register the device option, as well as the
printer host name and the IP address.
See p.4 "Using the Installation Shell Script".
B B B B
Start printing.
See p.13 "Printing Method".

Using the rsh / rcp / ftp commands

A A A A
Edit the host file to register the printer host name and the IP address.
B B B B
Start printing.
See p.13 "Printing Method".
Reference
See p.8 "After Executing the Installation Shell Script" for host file editing.
Note
❒ If you cannot edit the host file, use the install shell script to register the host
name.

1. UNIX Configuration

3