Sharp MX-C407F User Manual page 73

Understanding the printer menus
Menu item
Toner patch sensor setup
Calibration frequency preference
Disabled
Fewest color adjustments
Fewer color adjustments
Normal*
Better color accuracy
Best color accuracy
Toner patch sensor setup
Full calibration
Toner patch sensor setup
Print TPS information page
Scanner Configuration
Scanner Manual Registration
Print Quick Test
Scanner Configuration
Scanner Manual Registration
Front ADF Registration
Rear ADF Registration
Flatbed Registration
Scanner Configuration
Reset Maintenance Counter
Scanner Configuration
Edge Erase
Flatbed Edge Erase (3*)
ADF Edge Erase (3*)
Scanner Configuration
ADF Deskew
ADF Mechanical Deskew (On*)
ADF Electronic Deskew (On*)
Scanner Configuration
Disable Scanner
Enabled*
Disabled
ADF Disabled
Scanner Configuration
Tiff Byte Order
CPU Endianness*
Little Endian
Big Endian
Note: An asterisk (*) next to a value indicates the factory default setting.
Description
Set the printer to put down the correct amount of toner to
maintain color consistency.
Run the full color calibration.
Print a diagnostic page that contains information on toner patch
sensor calibration.
Print a Quick Test target page.
Note: Make sure that the margin spacing on the target page
is uniform all the way around the target. If it is not, then the
printer margins must be reset.
Manually register the flatbed and ADF after replacing the ADF,
scanner glass, or controller board.
Reset the counter after replacing the ADF maintenance kit.
Set the size, in millimeters, of the no‑print area around an ADF
or flatbed scan job.
Reduce skewing of documents that are scanned from the ADF.
Disable the scanner when it is not working properly.
Set the byte order of a TIFF‑formatted scan output.
73