Table of Contents
Advertisement
Removing the power button with fingerprint
WARNING:
Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in
Before working inside your
your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
NOTE:
Applicable only for computers that are shipped with fingerprint reader.
Prerequisites
NOTE:
The power button with fingerprint reader is shipped only with the non-touchscreen configuration of the Inspiron 7380.
1
Remove the
base
cover.
2
Remove the
wireless
card.
3
Remove the
I/O
board.
Procedure
1
Open the latch and disconnect the power button with fingerprint reader cable from the system board.
2
Open the latch and disconnect the power button with fingerprint reader cable from the power button with fingerprint reader
connector cable.
3
Peel off the power button with fingerprint reader cable from the fan.
4
Remove the two screws (M2x2.5) securing the power button with fingerprint reader to the palm-rest assembly.
5
Peeling off the cable connector of the power button with fingerprint reader from the keyboard bracket. Then lift the power button
with fingerprint reader from the slot on the palm-rest assembly.
52
Removing the power button with fingerprint reader
computer. After working inside your computer, follow the instructions in
31
reader
After working inside
www.dell.com/
Advertisement
Table of Contents
