Table of Contents
Advertisement
Steps
1. Turn the mylar to find the memory-module slot.
2. Align the notch on the memory module with the tab on the memory-module slot.
3. Slide the memory module firmly into the slot at an angle.
4. Press the memory module down until it clicks into place.
NOTE:
If you do not hear the click, remove the memory module and reinstall it.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Solid-state drive—M.2 slot one
Removing the 2230 solid-state drive in M.2 slot one
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
About this task
NOTE:
This procedure applies only to computers shipped with a 2230 solid-state drive installed in M.2 slot one.
NOTE:
Depending on the configuration ordered, your computer may be shipped with one of the following:
● One hard drive and one 2230 or 2280 solid-state drive
● One 2230 solid-state drive and one 2280 solid-state drive
NOTE:
Depending on the configuration ordered, your computer may support either 2230 solid-state drive or 2280 solid-
state drive in M.2 slot one.
20
Removing and installing components
After working inside your
Before working inside your
computer.
computer.
Advertisement
Table of Contents
