Connecting Water Supply; Connecting To The Drain - Beko WML 60611 M Manual

C Keep the transportation safety bolts in
a safe place to reuse when the washing
machine needs to be moved again in
the future.
C Never move the product without the
transportation safety bolts properly fixed
in place!

Connecting water supply

C The water supply pressure required to
run the product is between 1 to 10 bars
(0.1 – 10 MPa). It is necessary to have
10 – 80 liters of water flowing from the
fully open tap in one minute to have
your machine run smoothly. Attach
a pressure reducing valve if water
pressure is higher.
C If you are going to use the double
water-inlet product as a single (cold)
water-inlet unit, you must install the
supplied stopper to the hot water valve
before operating the product. (Applies
for the products supplied with a blind
stopper group.)
C If you want to use both water inlets of
the product, connect the hot water
hose after removing the stopper and
gasket group from the hot water valve.
(Applies for the products supplied with a
blind stopper group.)
A
Models with a single water inlet should
not be connected to the hot water
tap. In such a case the laundry will get
damaged or the product will switch to
protection mode and will not operate.
A
Do not use old or used water inlet
hoses on the new product. It may
cause stains on your laundry.
1. Connect the special hoses supplied
with the product to the water inlets on
the product. Red hose (left) (max. 90
ºC) is for hot water inlet, blue hose (right)
(max. 25 ºC) is for cold water inlet.
A Ensure that the cold and hot water
connections are made correctly when
installing the product. Otherwise, your
laundry will come out hot at the end of
the washing process and wear out.
2. Tighten all hose nuts by hand. Never
use a wrench when tightening the nuts.
3. Open the taps completely after making
the hose connection to check for water
leaks at the connection points. If any
leaks occur, turn off the tap and remove
the nut. Retighten the nut carefully after
checking the seal. To prevent water
leakages and damages caused by
them, keep the taps closed when the
machine is not in use.

Connecting to the drain

• The end of the drain hose must be
directly connected to the wastewater
drain or to the washbasin.
A Your house will be flooded if the
hose comes out of its housing during
water discharge. Moreover, there is
risk of scalding due to high washing
temperatures! To prevent such
situations and to ensure smooth water
intake and discharge of the machine, fix
the end of the discharge hose tightly so
that it cannot come out.
• The hose should be attached to a
height of at least 40 cm, and 100 cm at
most.
• In case the hose is elevated after
laying it on the floor level or close to
38
EN