Advancing To The Next Leg Of The Route; Erasing A Route - Raymarine RayChart 630 Owner's Handbook Manual

36
If you are already navigating to a waypoint (either by following a route or
using the GO TO option), a warning message is displayed (see page 39).
To stop following the current route, select the OFF option from the ROUTE menu.
This option replaces the FOLLOW option when the route is already active.

Advancing to the Next Leg of the Route

When you reach the active waypoint, the chartplotter automatically makes the
next waypoint in the route active.
The alarm buzzer sounds and a message is displayed when either of the
following conditions is met:
• If you have set the Arrival Alarm and the vessel has reached the arrival circle
specified for this alarm.
• Your vessel passes the target (that is, it crosses the line perpendicular to the
route leg, and through the target).
The alarm is cleared after 7 seconds. You can clear the alarm earlier by pressing
any key.
Arrival Alarm
to 008WPT
Any key to CLEAR
You can also advance to the next leg even if you have not reached the current
waypoint. From the ROUTE menu, highlight the NEXT LEG option and press
ENTER. The chartplotter starts tracking from the vessel's current position
towards the next waypoint.

Erasing a Route

The chartplotter can store up to 20 routes. If you already have 20 routes and
want to create a new route, you can erase a selected route.
Note: If required, you can store routes on a Memory C-Card for future use, as
described in Chapter 6, before deleting them from the chartplotter's memory.
To erase an existing route:
1. Press the ROUTE soft key to display the Route menu.
2. Press SELECT until the required route is displayed.
3. Use the trackpad or ROUTE soft key to highlight the ERASE option, and press
ENTER.
4. Press ENTER to confirm the deletion.
The route disappears from the screen, and the route soft keys are cleared.
D3832-1
RayChart 620 and 630