Displaying Information About Objects - Raymarine RayChart 630 Owner's Handbook Manual

16
The boundary of each chart digitized in the displayed card is shown as a box or
rectangle. (You can switch off the chart boundaries display if you wish, as part
of the chartplotter setup described in Chapter 6).
To zoom in:
1. Use the trackpad to move the cursor inside one of the chart boxes, and press
the lower part of the RANGE key.
That area is expanded so that you can see more detail. Note that the smaller
the chart box is on the screen, the greater the amount of detail that is
available when you zoom in.
Note: You cannot zoom out further than the world map and, unless you
have switched on the Plotter Mode, you cannot zoom in further than the
most detailed chart.

Displaying Information About Objects

Chart cards include a number of displayed objects for which information is
available, such as lights and buoys. Chart source data is also available and, if
your chart includes port and tide data, this can be displayed. You can use the
cursor to identify the object and display detailed information. In addition,
position information is available for waypoints and events added using the
chartplotter functions.
To obtain the chart object information:
1. Move the cursor over the symbol for which you require the information.
After a moment, an Object data box appears at the top of the screen, as
shown at the top of the example below.
If the cursor is over more than one object for which information is available,
the number of objects is shown and their descriptions are listed.
2. To view further details, press ENTER. The soft keys EXPAND, ALLINFO and
NEAREST are displayed.
3. To obtain expanded information about the object(s):
a.
a window in the center of the screen.
b.
required object or sub-object.
c.
If there is more than one page of information for the object, you can
page through it using the PAGE DN soft key, and go back to the beginning
using the BACK soft key.
d.
required.
Press the EXPAND soft key. The objects and any sub-objects are listed in
Use the trackpad to scroll up and down the list, and highlight the
Press ENTER. Any available information is displayed.
Press CLEAR to return to the expanded list, and select another object if
RayChart 620 and 630