Konica Minolta bizhub 4750i Quick Manual page 11

1.3 Safety information
CAUTION
Whenever moving this product, be sure to disconnect the power cord and other cables. Failure
to do this could damage the cord or cable, resulting in a fire, electrical shock, or breakdown.
When moving this product, always hold it at the locations specified in the User's Guide or other
documents. If the unit is moved while held at locations other than those specified, it may fall,
causing severe personal injury.
Using the product
WARNING
Do not modify this product, as a fire, electrical shock, or breakdown could result. If the product
employs a laser, the laser beam source could cause blindness.
Do not attempt to remove the covers and panels which have been fixed to the product. Some
products have a high-voltage part or a laser beam source inside that could cause an electrical
shock or blindness.
Do not keep using this product, if this product becomes inordinately hot or emits smoke, or
unusual odor or noise. Immediately turn OFF the power switch, unplug the power cord from
the power outlet, and then call your Technical Representative or your authorized service rep-
resentative.
If you keep on using it as is, a fire or electrical shock could result.
Do not keep using this product, if this product has been dropped or its cover damaged. Im-
mediately turn OFF the power switch, unplug the power cord from the power outlet, and then
call your Technical Representative or your authorized service representative. If you keep on
using it as is, a fire or electrical shock could result.
Do not use flammable sprays, liquids, or gases inside or near this machine. Do not clean the
inside of this machine using a flammable gas duster. A fire or explosion could result.
<If an RFID module (limited only to 13.56 MHz) for use in inside-the-machine proximity com-
munication or electromagnetic induction heating (IH) technology (limited only to 20.05 kHz to
100 kHz) is being used>
This machine generates a weak magnetic field.
If you experience any unusual symptoms with your implantable medical equipment (cardiac
pacemaker, etc.) while near the machine, move away from the machine and see a doctor im-
mediately.
Please call your Technical Representative or your authorized service representative if you do
not understand the purchased product corresponds or not.
<If a non-contact IC card reader is being used>
If you use an implantable medical equipment (cardiac pacemaker, etc.), do not bring the IC
card reader close from the implant within 12 cm at all times.
The radio waves may affect implantable medical equipment (cardiac pacemaker, etc.) opera-
tions.
CAUTION
Using this product in a poorly ventilated room for a long time or producing a large volume of
copies or prints may cause the odor of exhaust air from the machine. Ventilate the room well.
The inside of this product has areas subject to high temperature, which may cause burns.
When checking the inside of the unit for malfunctions such as a paper misfeed, do not touch
the locations (around the fusing unit, etc.) which are indicated by a "Caution HOT" caution la-
bel. A burn could result.
Unplug the product when you will not use the product for long periods of time.
When using the machine, do not look at the light of the lamp for a prolonged time. Eyestrain
could result.
Do not use stapled paper, conductive paper (such as silver paper or carbon paper) or treated
heat-sensitive/inkjet paper, otherwise a fire may result.
bizhub 4750i/4050i
1
1-7