Table of Contents
Advertisement
STEP 5 (See Diagram 5)
A.) Attach the Right Butterfly (#9) to the Upper Frame (#10). Slide a ∅1 ½" Washer (#51) and
∅1 3/8" Steel Cap (#84) onto the axle. Secure the Cap with a M6 x 1 ½" Hex Bolt (#106)
and M6 Aircraft Nut (#113). Attach a ∅1 ½" Washer (#58) and Butterfly Handle (#46) to the
Right Butterfly (#9). Secure it with a M10 x 5/8" Allen Bolt (#102) and ∅ ¾" Washer (#114).
B.) Repeat the step (A) above to install the Left Butterfly (#8).
C.) Attach a Butterfly Pulley Bracket (#11) to the hole on top of the Front Vertical Beam (#3).
Secure it with a M12 x 4 ¼" Hex Bolt (#90), ∅ 1" Washer (#117) and M12 Aircraft Nut
(#111). DO NOT over tighten the nut and bolt. Make sure the Bracket is able to swivel.
D.) Repeat the step (C) above to install the other Butterfly Pulley Bracket on the other side.
9
DIAGRAM 5
Advertisement
Table of Contents
