Simulator Mode - Raymarine hsb2 Owner's Handbook Manual

Chapter 2: Getting Started & Adjusting the Display
reaches zero a beep sounds, and the display unit switches off. Release the
POWER key.
Note: Switch the display unit off before you remove the power cord.
Countdown timer:
number of seconds
to power off
SECONDS
Figure 2-4:
Note: You do not need to change to Standby mode before turning off the dis-
play: if you turn the radar display off while it is in Transmit mode, the scanner
is also de-activated.

Simulator Mode

When simulator mode is on a simulator database box is displayed.
When the display is switched off then on again, simulator mode is maintained.
It is recommended that you select the System Set Up Menu and switch off
simulator mode when you have finished.
➤ To view simulated image:
1. Press MENU followed by the SYSTEM SET UP soft key.
MENU
The set up menu pop-up is displayed.
2. Use the trackpad to move the selection bar over the option SIMULATOR. The
simulator soft keys are displayed.
3. In the system set up menu, press RADAR to view a simulated radar image,
DATA to view the chart display with simulated position, or BOTH to view
simulated fishfinder and chart data
4. Press ENTER twice to return to the default display.
Note: Any waypoints placed on the chartplotter in simulator mode are re-
tained in the database list and are available for use in routes.
POWER
3
Switch Off
POWER OFF IN
3s
2-5
GAIN DISPLAY
VRM/EBL
MARKS
MULTI
ALARMS RANGE
ENTER CLEAR MENU
D3599-1