Table of Contents
Advertisement
6.2 Printer Function
1. Select the PC interface connected with bar code printer.
The default interface setting is
USB interface. If USB interface
is connected with printer, no
other settings need to be
changed in the interface field.
2. Click the "Printer Function" button to setup.
3. The detail functions in the Printer Function Group are listed as below.
For more information about Diagnostic Tool, please refer to the diagnostic utility quick start
zenpert official
guide on
Function
Calibrate Sensor
Ethernet Setup
RTC Setup
Factory Default
Reset Printer
Print Test Page
Configuration Page
Dump Text
Ignore AUTO.BAS
Exit Line Mode
Password Setup
website.
1
Description
Calibrate the sensor specified in the Printer
Setup group media sensor field
Setup the IP address, subnet mask, gateway for
the on board Ethernet
Synchronize printer Real Time Clock with PC
Initialize the printer and restore the settings to
factory default. (Please refer section 5.3)
Reboot printer
Print a test page
Print printer configuration (Please refer section
5.2)
To activate the printer dump mode.
Ignore the downloaded AUTO.BAS program
Exit line mode.
Set the password to protect the settings
28
2
Advertisement
Table of Contents
