5.3 Printer Initialization
Printer initialization is used to clear DRAM and restore printer settings to defaults.
Printer initialization is activated by the following procedures.
1. Turn off the power switch (
2. Hold on the FEED button (
3. Release the FEED button (
blinking. (Any blink will do during the 5 blinks).
Printer configuration will be restored to defaults as below after initialization.
Parameter
Speed
Density
Media Width
Media Height
Print Direction
Reference Point
Offset
Code Page
Clear Flash Memory
).
) then turn on the power switch (
) when the indicator becomes
Default setting
50.8 mm/sec (2 ips)
8
2.84" (72 mm)
4" (101.5 mm)
0
0,0 (upper left corner)
0
850
No
26
).
Initialize.....
and