Advertisement
Shaver turns
off with fully
charged
battery.
Battery
segments in the
display are
skipped with
decreasing
battery
capacity.
Shaving parts
have been
changed
recently but
replacement
symbol lights up.
Shaver head is
damp.
CLEAN&RENEW STATION
Cleaning does
not start when
pressing the
start button.
Increased
consumption of
cleaning fluid.
30
Foil and cutter are worn
which requires more power
than the motor can deliver.
The appliance turns off.
Foil and cutter are worn
which requires more power
for each shave.
Reset button has not been
pushed.
1. Drying time after
automatic cleaning was
too short.
2. Drain of the Clean&Renew
station is clogged.
3. Cleaning cartridge has
been used for quite a
while.
1. Shaver is not placed
properly in the
Clean&Renew station.
2. Cleaning cartridge
contains not enough
cleaning fluid (display
lights red).
3. Appliance is in stand-by
mode.
Drain of the Clean&Renew
station is clogged.
– Renew Foil & Cutter cassette.
– Regularly oil the shaving system,
especially when cleaning with water
only.
– Renew Foil & Cutter cassette.
– Regularly oil the shaving system,
especially when cleaning with water
only.
– Push the reset button for at least 3
seconds to reset the counter.
1. Clean directly after shaving to allow
enough time for drying.
2. Clean the drain with a wooden
toothpick. Regularly wipe the tub
clean.
3. The ethanol/isopropanol proportion
has decreased while the oil
proportion has increased. Remove
residue with a cloth.
1. Insert shaver into the Clean&Renew
station (contacts of the shaver
need to align with contacts in the
station).
2. Insert new cleaning cartridge.
3. Press start button again.
– Clean the drain with a wooden
toothpick.
– Regularly wipe the tub clean.
Advertisement
