Programming A Power Off Macro - Home Theater Master MX700 Manual

9 Again, turn the TV and the Receiver to the wrong input, then turn off everything in the theater. Point the
connected MX700 at the system. Select the first step in the list by clicking on it. Now, click on the TEST
button. Observe the television and the receiver. Did they both switch to the correct input? Continue to
revise the macro with delays or changes in order and test until the macro ALWAYS correctly turns every-
thing on and switches the surround sound receiver and television to the correct input.
When the macro is perfect, click on the SAVE

Programming a Power Off Macro

The Power Off macro is much simpler than a Power On macro, since there are rarely any delays to test etc. Usually,
to give the client some feedback that the macro is working, the TV is turned off first.
When you are forced to "workaround" a DVD player or VCR without a discrete off command, you will make the
macro more reliable if you place the time consuming anchor (the play command) at the beginning of the macro.
Make sure that you turn the DVD player off before testing this kind of workaround. You are testing the worst case,
you know that a toggle type power command will turn the DVD player off, you are concerned about an event that
might happen.The DVD player is already off, but the client presses the MAIN Power Off to turn everything else on. If
you only programmed a toggle Power command, everything else would turn off, but the DVD player would turn on.
This "workaround" ensures that the DVD player turns off.
Step by Step Tutorial
shortcut button.
Play command turns on DVD player if OFF. If it is
already on, it stays on.
Other power commands provide enough delay
that the DVD player will respond to a Power
command if the play command just turned it off.
Power command turns off DVD player.
33
T
H
E
M
X
7
0
0
D
U
A
L
R
E
M
O
T
E
S
Y
S
T
E
M