Disassembly Procedure - Mitsubishi Electric SUZ-SWM40VA Technical & Service Manual

11

DISASSEMBLY PROCEDURE

<"Terminal with locking mechanism" Detaching points>
The terminal which has the locking mechanism can be detached as shown below.
There are 2 types (Refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not.
Sleeve
Locking lever
SUZ-SWM40VA.TH
SUZ-SWM60VA.TH
SUZ-SWM80VA.TH
OPERATING PROCEDURE
1. Removing the cabinet
(1) Remove the screws of the service panel.
(2) Remove the screws of the top panel.
(3) Remove the screw of the valve cover.
(4) Remove the service panel.
(5) Remove the top panel.
(6) Remove the valve cover.
(7) Disconnect the power supply and indoor/outdoor connect-
ing wire.
(8) Remove the screws of the cabinet.
(9) Remove the cabinet.
(10) Remove the screws of the back panel.
(11) Remove the back panel.
Photo 2
Screws of the top panel
Screws of
the cabinet
Screw of Screws of
the valve cover the service panel
OCH718A
1Slide the sleeve.
2Pull the terminal while
pushing the locking
lever.
Screw of the back panel
Screws of
the cabinet
Screws of
the back panel
29
(2) The terminal with this connector has the
locking mechanism.
1Hold the sleeve, and
pull out the terminal
slowly.
Connector
: Indicates the visible parts in the photos/figures.
: Indicates the invisible parts in the photos/figures.
NOTE: Turn OFF the power supply before disassembly.
PHOTOS/FIGURES
Photo 1
Screws of the top panel
Screws of
the cabinet
Screws of
the cabinet