Table of Contents
Advertisement
6.
Lift the tape from atop the connector on the display panel (1), lift the locking latch (2), and then
disconnect the cable from the panel (3).
7.
Use the following steps to install a display panel:
a.
Remove the backing from the bottom of the new tape to install in the display enclosure (1).
b.
Install the tape onto the left and right sides of the enclosure from the bottom (2) to the top (3).
c.
Remove the backing from the top of the installed tape (4).
d.
Rotate the panel into place in the display enclosure (5).
Component replacement procedures
59
Advertisement
Table of Contents
