Table of Contents
Advertisement
517766B
16.3
SmartDrive Diagnostic Table - GW Only
To use this table, firstly enter Diagnostic Mode. The different levels of information can be
extracted by using the Spin Speed up and down buttons.
Diagnostic
Spin Speed LEDs
Mode
Fast
Med
0
OFF OFF OFF OFF
1
OFF OFF OFF ON
2
OFF OFF ON
3
OFF OFF ON
4
OFF ON
5
OFF ON
6
OFF ON
7
OFF ON
8
ON
OFF OFF OFF
9
ON
OFF OFF ON
10
ON
OFF ON
11
ON
OFF ON
12
ON
ON
13
ON
ON
14
ON
ON
15
ON
ON
16.4
User Warnings - GW
There are a number of warnings, which are generally caused by the user or poor
installation. The user generally can correct these warnings. SmartDrive signals user
warnings by flashing LEDs and a rippling set of 5 beeps repeated every 6 seconds. This is
the same tone that is heard when SmartDrive is first plugged into the mains power. Some
warnings are indicated by the wash progress LEDs flashing and no user warning tone,
(Restart or Recycle mode). Most of this information is available to the user in the 'Use and
Care Manual'
Diagnostic Info Displayed
Slow Hold
Last User Warning Number
Last User Warning Cycle Position
OFF
HVDC setting (used by auto WL sense agitate)
ON
Fault Code at last fault (if within the last 8
cycles)
OFF OFF
OOB status
OFF ON
Cycle count at last fault (low byte)
ON
OFF
Cycle count at last fault (high byte)
ON
ON
Cycle position at last fault
Water Temp (deg C)
Cycle count (low byte)
OFF
Cycle count (high byte)
ON
Motor speed (rpm/10)
OFF OFF
Water Level
OFF ON
EEPROM version number
ON
OFF
Software Version number
ON
ON
(F&P development use only)
- 15 -
May 2004
Hide quick links:
Advertisement
Table of Contents
