Before You Start; Setting The Clock - Danfoss 103E5 Installation And User Manual

Before you start

 Open the fl ap on the front of
the unit.
 Press all four buttons
(SELECT / ADVANCE / + / -)
at the same time
This will reset the unit, reinstate the
preset programmes and set the time to
12:00pm on Monday.

Setting the clock

 Press PROGRAMME once
 Use + and – buttons to set the
correct time
 When time is correct press
PROGRAMME again.
In 24 hour mode this will take you
straight to programming mode,
where you can select your own ON
and OFF times.
In 5/2 day mode this will fi rst allow you to programme the
correct DAY. To do this:

use the + or – buttons to select the correct day

press PROGRAMME again to enter RUN mode
14
- PROGRAMME
+
+ - PROGRAMME
-
+ PROGRAMME