Table of Contents
Advertisement
AutoDome Modular Camera System
2.10
Make Connections in Power Supply Box
The following procedure references Figure 2.6 on page 25 to locate the various connectors in
the box and to make the proper connections.
1.
Attach the earth ground wire to the grounding screw on the left side of the box.
2.
Connect the 24 VAC to Dome plug, installed previously, to its mating connector P107 on
the right side of the box.
3.
Connect the 115/230 VAC, 3-pin Power-In plug, installed previously, to its matting con-
nector P101 on the left side of the box.
2.10.1
Connections for Fiber Optic Models
The following procedure references Figure 2.5 on page 24.
1.
If installing a Fiber Optic model, attach the incoming ST fiber plug to its mating connector
on the Fiber Optic Module in the power box.
2.
Connect the video BNC connector from the dome to the Fiber Optic Module BNC connec-
tor.
NOTICE! A BNC barrel connector (not supplied) is required to connect the male BNC of the
i
dome to the male BNC connector of the Fiber Optic Module.
3.
Connect the six (6) control plugs from the dome, installed previously, to the P106 control
I/O connector in the Power Supply Box.
Removing the Pendant Bubble
To service the AutoDome Pendant, use the following procedure to remove the Bubble:
1.
Using both hands, apply a firm counterclockwise (looking up at the dome) rotational
force on the Pendant Bubble Assembly to set the bubble latch.
2.
Insert a small (2 mm) straight blade screw driver into the release opening in the bubble
trim-ring to release the lock, and then remove the screwdriver.
Fig. 2.18 Pendant Bubble Release Opening
3.
Firmly rotate the bubble counterclockwise approximately 20 degrees until the bubble
assembly releases from the Pendant Housing.
Bosch Security Systems, Inc.
Installing Roof Parapet and Pipe Mounts | en
Installation Manual
37
F01U010921 | 1.0 | 2006.10
Advertisement
Table of Contents
