Table of Contents
Advertisement
AutoDome Modular Camera System
1.8
Attach Pendant to Arm and Tighten
NOTICE! Before attaching the AutoDome Pendant, visually inspect the dome and arm
i
connectors for any blocked pin holes or bent pins.
1.
Tilt the bottom of the dome toward the pendant arm base and place the mounting hook,
located on top of the dome housing, over the recessed hinge pin of the arm.
Fig. 1.12 AutoDome to Pendant Arm Attachment
2.
Drop the dome housing down slightly to engage the dome housing hook on the Pendant
Arm hinge pin, allowing the dome to rotate around the pin.
3.
Rotate the dome housing down to a vertical position and gently push upward to engage
the connector on top of the dome housing.
CAUTION! If you feel any resistance when rotating the dome housing or when engaging the
connector, stop immediately and start over.
4.
Hold the Pendant housing in position while tightening the two (2) 5-mm Allen head
mounting screws on top of the housing to 10-12 N-m (90-105 in.-lbs).
Bosch Security Systems, Inc.
Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en 15
2. Hook and
2. HOOK
Drop
AND DROP
1. Tilt Up
1. TILT UP
3. Rotate Down to
3. ROTATE DOWN
Engage Dome
TO ENGAGE
Connector
DOME CONNECTOR
Installation Manual
Recessed Hinge Pin
RECESSED
HINGE PIN
Dome Connector
DOME CONNECTOR
4. Tighten Two (2)
4. TIGHTEN TWO (2)
Mounting Screws
MOUNTING SCREWS
F01U010921 | 1.0 | 2006.10
Advertisement
Table of Contents
