Table of Contents
Advertisement
26
en | Installing Roof Parapet and Pipe Mounts
2.5
Installing the VG4-A-9230 Roof Parapet Mount
This section details the installation steps for the Roof Parapet Mount. If you are installing a
pipe mount, see Section 2.6: Installing the VG4-A-9543 Pipe Mount on page 30 for instructions.
Fig. 2.7 VGA-A-9230 Parapet Roof Mount
1.
Determine the wall location on the roof for the AutoDome and use the Parapet wall
mount bracket as a template to mark the hole locations.
NOTICE! Allow enough room below the Parapet Mount Bracket to route the video, control and
alarm wires up through the Parapet arm. In certain installations you may have to lift the
i
Parapet arm for the AutoDome to clear the top of the wall when it is swung into position.
Provide enough slack in the wires to rotate the pipe arm over the roof and back when camera
maintenance is required.
F01U010921 | 1.0 | 2006.10
Installation Manual
AutoDome Modular Camera System
Bosch Security Systems, Inc.
Advertisement
Table of Contents
