16 SERVICE WORK ON THE ENGINE
16.4
108
V01532-10
K00530-10
Adding the gear oil
Info
Too little gear oil or poor-quality gear oil results in premature wear to the transmission.
Gear oil must only be topped up when the engine is cold.
Main work
–
Remove gear oil drain plug
–
Remove gear oil drain plug
–
Let the gear oil drain fully.
–
Thoroughly clean the gear oil drain plug.
–
Clean the sealing surface on the engine.
–
Mount and tighten gear oil drain plug
a new seal ring.
Guideline
Gear oil drain plug
with magnet
–
Mount and tighten gear oil drain plug
Guideline
Gear oil drain plug
–
3
Remove filler plug
with the O-ring, and fill up with gear oil.
Gear oil
–
Mount and tighten the filler plug together with the O-ring.
Danger
Danger of poisoning Exhaust gases are toxic and inhal-
ing them may result in unconsciousness and death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use effective exhaust extraction when starting or
running the engine in an enclosed space.
–
Start the engine and check that it is oil-tight.
Finishing work
–
Check the gear oil level. (
Preparatory work
–
Park the motorcycle on a level surface.
1
with magnet.
2
.
1
with the magnet and
M12x1.5
20 Nm (14.8 lbf ft)
2
with a new seal ring.
M10x1
15 Nm (11.1 lbf ft)
0.80 l
Engine oil
(0.85 qt.)
(15W/50)
(
p. 128)
p. 107)