General Procedure - Siemens SIMATIC NET RUGGEDCOM RSG909R Installation Manual

Installing the Device
2.1 General Procedure
This product contains no user-serviceable parts. Attempted service by unauthorized
personnel shall render all warranties null and void.
Changes or modifications not expressly approved by Siemens Canada Ltd. could
invalidate specifications, test results, and agency approvals, and void the user's
authority to operate the equipment.
This product should be installed in a restricted access location where access can only
be gained by authorized personnel who have been informed of the restrictions and
any precautions that must be taken. Access must only be possible through the use
of a tool, lock and key, or other means of security, and controlled by the authority
responsible for the location.
2.1

General Procedure

The general procedure for installing the device is as follows:
Note
The user is responsible for the operating environment of the device, including
maintaining the integrity of all protective conductor connections and checking
equipment ratings. Make sure to review all operating and installation instructions
before commissioning or performing maintenance on the device.
1.
2.
3.
4.
5.
6.
8
NOTICE
NOTICE
Review the relevant certification information for any regulatory
requirements.
For more information, refer to "Approvals" (Page 35).
Unpack and inspect the device.
For more information, refer to "Unpacking the device" (Page 9).
Mount the device.
For more information, refer to "Mounting the Device" (Page 9).
Connect the failsafe alarm relay.
For more information, refer to "Connecting the Failsafe Alarm
Relay" (Page 13).
Connect power and ground the device.
For more information, refer to "Connecting Power" (Page 14).
Connect the device to the network.
For more information, refer to "Connecting the Device to the
Network" (Page 20).
RUGGEDCOM RSG909R
Installation Manual, 04/2023, C79000-G8976-1388-17