Power Cord Connection; Installing The Hardwire Kit - Whistler MAXIMUM PERFORMANCE User Manual

INSTALLATION

Power Cord Connection

• Plug the small end of the power cord into the unit's power
jack.
• Plug the large end into the vehicle's cigarette lighter socket.
NOTE: Cord fits tightly into detector. When installing the
cord, expect some resistance.

Installing the Hardwire Kit

The "U" type connector must be secured to a metal surface
that is electrically connected to the battery ground (negative)
terminal.
The spade type connector can connect to either live 12 volts
or switched 12 volts at your fuse panel accessory port. If no
port is available, cut off the spade terminal, expose 1/4 to 1/2
inch of wire, and splice into a source of 12 volt power.
10