Lenovo 7Z46 Manual page 24

Enclosures. messages and codes reference
Hide thumbs Also See for 7Z46:
Table of Contents

Advertisement

Table 2. Events organized by severity (continued)
Message String
Event ID
FQXSPBR4008I
Management Controller [arg1]: Configuration restoration from a file by
user [arg2] failed to start.
FQXSPCA0002M
Numeric sensor [NumericSensorElementName] going low (lower
critical) has asserted.
FQXSPCA0009M
Numeric sensor [NumericSensorElementName] going high (upper
critical) has asserted.
FQXSPCA0011N
Numeric sensor [NumericSensorElementName] going high (upper
non-recoverable) has asserted.
FQXSPCA0017M
Sensor [SensorElementName] has transitioned to critical from a less
severe state.
FQXSPCA0019N
Sensor [SensorElementName] has transitioned to non-recoverable
from a less severe state.
FQXSPCR0001N
Sensor [SensorElementName] has transitioned to non-recoverable
from a less severe state.
FQXSPFW0000N
The System [ComputerSystemElementName] encountered a POST
Error.
FQXSPFW0001N
Firmware BIOS (ROM) corruption was detected on system
[ComputerSystemElementName] during POST.
FQXSPFW0002N
The System [ComputerSystemElementName] encountered a firmware
hang.
FQXSPIO0003N
A diagnostic interrupt has occurred on system
[ComputerSystemElementName].
FQXSPIO0004L
A bus timeout has occurred on bus [SensorElementName].
FQXSPIO0006N
A software NMI has occurred on system
[ComputerSystemElementName].
FQXSPIO0011N
An Uncorrectable Error has occurred on [SensorElementName].
FQXSPIO0013N
A Fatal Bus Error has occurred on bus [SensorElementName].
FQXSPIO0015M
Fault in slot [PhysicalConnectorSystemElementName] on system
[ComputerSystemElementName].
FQXSPMA0002N
Configuration Error for [PhysicalMemoryElementName] on Subsystem
[MemoryElementName].
FQXSPMA0005N
Subsystem [MemoryElementName] has insufficient memory for
operation.
FQXSPMA0007L
Scrub Failure for [PhysicalMemoryElementName] on Subsystem
[MemoryElementName].
FQXSPMA0008N
Uncorrectable error detected for [PhysicalMemoryElementName] on
Subsystem [MemoryElementName].
FQXSPMA0012M
An Over-Temperature Condition has been detected on the
[PhysicalMemoryElementName] on Subsystem
[MemoryElementName].
FQXSPMA0013N
The System [ComputerSystemElementName] has detected no
memory in the system.
20
ThinkSystem SE350 and ThinkSystem SE350 Enclosures Messages and Codes Reference
Severity
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error

Advertisement

Table of Contents
loading

This manual is also suitable for:

Thinksystem se3507d1x7d277d1r

Table of Contents