Problem Solving Guide; Technical Problems - Miele marine PG 8059 Operating Instructions Manual

Problem solving guide

With the help of the following guide, minor faults in the performance of the machine, some
of which may result from incorrect operation, can be put right without contacting the
Service Department.
 Repair work to electrical appliances should only be carried out by an authorised
Miele service technician. Repairs and other work by unqualified persons could be
dangerous. The manufacturer cannot be held liable for unauthorised work.

Technical problems

Problem
When the dishwasher is
switched on with the
 button, the display stays
dark and the Start/Stop
indicator does not flash.
The dishwasher stops
during a programme.
One of the following fault
messages appears in the
display:
Check water inlet
Fault 403-405
Fault 406-408
100
Cause and remedy
The dishwasher is not plugged in, or connected to the
mains.
Insert the plug and switch on at the socket.

The fuse is defective or has tripped.
Reset the trip switch in the mains fuse box or replace the

fuse in the plug
(minimum fuse rating - see data plate).
The fuse is defective or has tripped.
Reset the trip switch in the mains fuse box or replace the

fuse in the plug (minimum fuse rating - see data plate).
If the mains fuse trips again, call the Miele Service

Department.
Before rectifying the problem:
Switch the dishwasher off with the  button.

Water inlet fault.
Open the stopcock fully.

Clean the filter in the water inlet (see "Cleaning and

care").
Check water inlet
If appears in the display, the control unit is
checking the water intake approx. every 30 seconds. If,
after three attempts, water is not getting into the
dishwasher, one of these fault numbers will appear in the
display and the programme will be cancelled.
Open the stopcock fully.

Switch the dishwasher back on.

Select the programme you want.

Press the Start/Stop button.

Water inlet fault.
One of these fault numbers will appear in the display if the
flow pressure is too low and the programme will be
cancelled.
The flow pressure at the water intake point is too low

(see "Technical data"). Contact Miele Service for advice.