Removal And Replacement Of Thermistor - Hoshizaki KM-1300SWH-E Service Manual

10. REMOVAL AND REPLACEMENT OF THERMISTOR

1. Fragile, handle very carefully.
2. Always use a recommended sealant (High Thermal Conductive Type),
Model KE4560RTV manufactured by SHINETSU SILICONE, Part Code
60Y000-11, or Part Code 4A0683-01 or equivalent.
3. Always use a recommended foam insulation (Non-absorbent Type) or
equivalent.
4. Do not shorten or cut the Thermistor leads when installing it.
1) Turn off the power supply. If the unit is
equipped with a plug, unplug it.
2) Remove the panels.
3) Remove the Control Box Cover.
4) Disconnect the Thermistor leads from
the K3 Connector on the Controller
Board.
5) Remove the Plastic Cable Ties, Foam
Insulation, Thermistor Holder and Ther-
mistor. See Fig. 2.
6) Scrape away the old sealant on the
Thermistor Holder and the Suction
Pipe.
7) Wipe off moisture or condensation on the Suction Pipe.
8) Smoothly apply recommended sealant (KE4560RTV, Part Code 60Y000-11 or
4A0683-01) to the Thermistor Holder concave.
9) Attach the new Thermistor to the Suction Pipe very carefully to prevent damage to
the leads. Secure the Thermistor using the Thermistor Holder and recommended
foam insulation.
CAUTION
Thermistor Lead
Foam Insulation
38
Cable Tie
Thermistor Holder
Fig. 2