Emptying Your Bin; Cleaning Your Bin - Dyson micro User Manual

Emptying your bin

Empty your bin as soon as the dirt reaches the MAX mark.
You may need to clean the filter more often if you use your machine with a full bin.
Remove your wand
Press the red wand release button, on the top of the wand, and pull the wand
away from the bin.
Release the dirt
Hold the machine over the bin, pointing downwards.
Firmly push the red bin release button. The bin will slide down, cleaning the
shroud as it goes, and the bin base will open.
The bin base won't open if the red bin release button isn't pushed down all
the way.
To remove the bin for emptying:
If the bin doesn't empty fully, remove the bin and empty the dirt.
Press the red button located on the bin runner to release the bin and slide
your bin off the runner.
Minimise dust contact
Cover your bin tightly in a dust proof bag while you empty. Remove your bin
carefully, seal the bag tightly and dispose.
Replace your bin
If you have removed your bin, slide it back on to the runner. Make sure that
the bin and lid are both securely in position.
Push the bin base upwards until the bin and lid both click into place.
Reconnect the wand.
Close the bin
Push the bin base upwards until your bin and bin base click into place.

Cleaning your bin

Don't put any part of your machine in a dishwasher or use detergents,
polishes or air fresheners.
Clean your bin
If it is necessary to clean your bin, empty it as shown in the 'Emptying your bin' section.
Press the red button located on the bin runner to release the bin and slide your bin off
the runner.
To clean your bin, you can use a damp, lint-free cloth, or run it under a stream of
water. Never fully submerge you bin under water. Once your bin is cleaned leave to
dry before reattaching.
Make sure that your bin and seals are completely dry before replacing.
Replace your bin
Insert the spine on to the bin runner.
Close your bin by pushing the bin base upwards until the bin and bin base
click into place.
The MAX mark on the bin of
the machine, showing that
the dirt should not be filled
over the Max mark when the
machine is at the angle of
normal use.
Illustration of the bin
being emptied.
1
2
The bin lid
closing with an
audible click and
the bin being
pushed upwards
with another
click once it is
fully in place.
Two images of the bin with arrows
showing the bin lid closing and
a click symbol and the bin being
pushed upwards with another
click symbol.
1
2
The bin being
removed and the
location of the bin
release lever on the
underside of the
bin runner.
Illustration of
the bin being
emptied into
a bag.
clik
2
clik
1
The bin being pushed
back into position on
the bin runner.