Biasi ADVANCE 25S User Manual page 65

Fig. 8.33
• Press keys 12 and 13 (Fig. 8.31) at the
same time to exit without changing the
value (return to the parameters list Fig.
8.32).
• Scroll the various parameters using keys
13 or 14 until the letters Pr that alternate
with code 02 are displayed on the LCD
display, indicating that "parameter 02" has
been activated.
• Repeat all the above setting sequences in
order to visualize the parameters and their
values.
• Set the following parameter:
PARAMETER
Type of water sensors
(C.H.)
Pump speed
Zone valve setting
Room Thermostat /
Remote Control
NTC on the C.H. return Pr 18
LCD type
NTC inlet probe
• Press sequentially keys, 12 - 13 and then
14 (Fig. 8.31) and hold in for 10 seconds
to exit the "programming mode".
ADVANCED COMMISSIONING
LCD VALUE
Pr 02 03
Pr 03 00
Pr 04
00
00
Pr 19 02
Pr 29 00
- 65 -