Table of Contents
Advertisement
e
(Audio): Press this key to view the AUDIO ADJUST
screen. See "Audio Adjust" screen later in this section.
ǻ
(Seek/Scan): To seek stations, press the up
or down arrow to go to the next or previous station
and stay there.
To scan stations, press and hold either arrow for
less than 2 seconds. The radio will go to a station,
play for a few seconds, then go on to the next station.
To stop scanning, press either arrow again or touch
the scan screen button.
Tuning Knob: Turn this knob to change frequencies.
Finding a Station
Press the band/source screen button, located in the
top left corner (AM, FM, CD, etc.), from any screen
to access the audio source screen. Once this screen
is displayed, press the BAND hard key to toggle
between the bands or touch the desired band
screen button, to select it.
FM source shown, other sources similar
Scan: To scan stations, touch the Scan screen button.
The radio will go to a station, play for a few seconds,
then go on to the next station. Touch Scan again to
stop scanning.
To scan preset stations, touch and hold Scan for
two seconds. The radio will go to the next preset station,
play for a few seconds, then go on to the next preset
station. Touch Scan again to stop scanning.
While in A.B.C mode, the system will change bands
and screens to the current band.
If available on your vehicle, you can also use the
1 - 6 (preset seek) steering wheel control. Each press
of this button will take you to the next preset station.
3-3
Advertisement
Table of Contents
