Recording mode
Setting Recording
EN
Mode
You can select between two recording
modes - manual recording and AVR
(automatic voice recording).
1. Manual Recording
Please refer to page 8.
2. AVR (Automatic
Voice Recording)
This feature allows the unit to sense
sound and to record only when you
are speaking into the microphone.
When dictation stops for about 3
seconds, recording will stop and then
start again automatically when you
resume dictation.
1. Select destination folder (1-4).
2. Press MENU
three times.
3. Press REVERSE
or FORWARD to
toggle between
AVR on and AVR
off.
4. Press STOP to
exit to STOP mode.
5. Press RECORD to enter AVR mode.
9
RP5010
6. During recording,
adjust the sensitivity of
the microphone by
pressing VOL UP and
VOL DOWN, SEN with
sensitivity value shows
on display (e.g.
increase sensitivity value when
recording source is far from the unit or
the recording envionment is quiet.).
7. Start dictation. Recording starts
automatically.
8. Press STOP to end AVR recording.
9. Repeat step 2 and select AVR OFF
for de-selection.
Tips:
• The first syllable or two may be
lost when you start recording
because this 'sound' is used to turn
on the AVR feature. It is a good
pratice to make some 'sounds' or say
a short word to activate the AVR
before you begin actual dictation.
11
8/9/02, 6:01 PM