Table of Contents
Advertisement
Open the lid on the plastic cover.
Screw off the cap and top up with coolant if
necessary. The coolant level must not exceed
the yellow MAX mark inside the expansion
tank.
Reinstall the parts in reverse order.
14
Some cars have no bulbs.
15
An authorised Volvo workshop is recommended.
LED (Light Emitting Diode)
16
IMPORTANT
Harmful if ingested. May cause organ
•
(kidney) damage.
Use ready-mixed coolant as recom-
•
mended by Volvo. If concentrated liquid is
used, make sure that the ratio is 50 %
coolant to 50 % water of an approved
quality.
Do not mix different coolants.
•
Only new coolant should be used when
•
replacing major cooling system compo-
nents to ensure the system has sufficient
corrosion protection.
The engine must only be run with a well-
•
filled cooling system. Otherwise, tempera-
tures that are too high may occur result-
ing in the risk of damage (cracks) in the
cylinder head.
A high content of chlorine, chlorides and
•
other salts may cause corrosion in the
cooling system.
Related information
Engine compartment overview (p. 587)
•
Coolant — specifications (p. 640)
•
MAINTENANCE AND SERVICE
Bulb replacement
Lamp types vary depending on model and
14
equipment level. If a bulb
breaks, it can be
replaced according to the method described in
the Owner's Manual.
15
Contact a workshop
if faults occur in lamps
other than bulbs.
16
If a fault occurs in LED
lamps, the entire lamp
unit usually must be replaced.
NOTE
For information about bulbs not covered in
this Owner's Manual, contact a Volvo dealer
or a certified Volvo service technician.
NOTE
Outside lighting such as headlamps and rear
lamps may temporarily have condensation on
the inside of the lens. This is normal, all exte-
rior lighting is designed to withstand this.
Condensation is normally vented out of the
lamp housing when the lamp has been
switched on for a time.
591
Advertisement
Chapters
Table of Contents
